Description

Chemforce TED Efflorescence Remover

1 and 5 Litres

Chemforce TED Efflorescence Remover is the efflorescence destroyer.
Chemforce TED Efflorescence Remover Removes efflorescence and rust marks from porous materials, including stone, concrete, brick and grout.

Benefits of TED™

Chemforce TED Efflorescence Remover Is a highly concentrated formulation.
It contains 50 to 60% Urea Hydrochloride
Powerful but much lower fuming than hydrochloric acid.
Effectively removes mineral residues, including efflorescence, grout haze, rust marks, soap scum, limescale, mortar mess.
Chemforce TED Efflorescence Remover is an acidic Cleaner which can also be used for removing fireplace soot.
Temporary contact does not immediately burn skin – you have some time to rinse off the Acidic Cleaner (however, rinse immediately after skin contact).
Almost no corrosion of metals, except aluminium.

HOW TO USE

Read Product Data Sheet and Material Safety Data Sheet before using.
Wear protective gloves/protective clothing/eye protection/face protection.
TEST PRODUCT ON A SMALL AREA TO CHECK ACID SENSITIVITY BEFORE FULL APPLICATION.
If satisfied with test results, remove all loose dust and dirt from the surface.
Apply when surface temperature is 5 to 35 °C (40 – 95 °F).
Pre-wet very porous surfaces with water to prevent cleaner penetrating too deeply.
TED™ is highly concentrated and must be diluted with clean water.
Recommended dilutions:
- Efflorescence, rust marks – 1 part TED™ to 10 parts water
- Grout haze, limescale, soap scum – 1 part TED™ to 20 parts water
Pour, brush or spray mixed solution generously onto surface and leave for 3 minutes.
Do not allow solution to dry on surface.
Clean large areas in sections.
Rub with a white nylon scrub pad, or similar, to clean the surface.
TED™ is highly acidic and must be neutralized before rinsing: Use Oxitec-M™ or dissolve 1 cup of bicarbonate of soda in a bucket of water. Pour, spray over the entire surface and leave for minimum 3 minutes.
Rinse surface thoroughly several times with clean water.
NOTE: TED™ is highly acidic and will etch acid sensitive materials such as marble, limestone, travertine and onyx. Concrete should be wet before applying TED™ and neutralized immediately afterwards to minimize damage.

SHELF LIFE AND STORAGE GUIDELINES

Best within 2 years of manufacture date. Store away from direct sunlight.
Keep container tightly sealed, in a well-ventilated place, at 2-300 Celsius / 36-850 Fahrenheit.

TRANSPORT

NOT CLASSIFIED AS A DANGEROUS GOOD BY THE CRITERIA OF THE ADG CODE, IMDG OR IATA

PACK SIZES

1L (1.06Q); 5L (1.3G); 20L (5.3G)

TECHNICAL DATA

Specific Gravity: 1.21
Colour: Clear colourless to light straw yellow liquid
Weight: 1L (1.06Q) = 1.3Kg (2.86Lb.); 5L (1.3G) = 6.3Kg (13.9Lb), 20L (5.3G) = 25Kg (55Lb),