Description
Hybrid Flooring Transition Ramp provides a smooth height transition between hybrid or hybrid-plank flooring and an adjoining surface, available in two opening heights to correctly match the specific flooring thickness being installed. Choosing the wrong height creates either a visible gap or a trim that sits proud of the floor, so matching the 5.5mm or 6.7mm opening to the actual plank thickness is the key decision at the start of any installation using this trim.
Its factory anodised colour treatment is a genuine practical detail for larger projects or staged installations — because the anodising happens at the factory rather than varying batch to batch, trim purchased at different times for the same job will still match visually once installed, rather than showing a subtle colour shift at the join. Each length is individually plastic wrapped, protecting the anodised finish during transport and storage before installation.
Supplied in 3.3 metre lengths across four anodised finishes — Matt Black, Matt Bronze, Matt Champagne and Matt Silver — it gives real flexibility to match the trim to the flooring colour or the surrounding fixtures and hardware, rather than being limited to a single generic metal tone across a whole project.
Because it’s individually plastic wrapped, the anodised finish stays protected right up until installation, avoiding the scuffs and marks that loose trims can pick up during transport and on-site storage. Matching the correct opening height precisely to the flooring thickness is the single most important decision when specifying this trim, since an incorrect match either leaves a visible gap or sits the trim proud of the finished floor.
Technical Specifications
| Opening heights | 5.5mm (for 5mm planks/hybrid), 6.7mm (for 6.5mm hybrid) |
|---|---|
| Length | 3.3 metres |
| Finishes | Matt Black, Matt Bronze, Matt Champagne, Matt Silver |
| Treatment | Factory anodised for batch consistency |
Where to Use
- Transitions between hybrid flooring and tile, carpet or another hard surface
- Doorways and room-to-room transitions
- Renovation projects requiring a clean height step at the flooring edge
How to Apply
- Measure the flooring thickness — confirm whether 5.5mm or 6.7mm opening height is correct.
- Select the matching finish — to coordinate with the flooring and surrounding fixtures.
- Cut the 3.3m length to size — trim to suit the doorway or transition width.
- Fix the ramp in place — securing it at the transition point per standard trim installation practice.
Important Notes
- Confirm the correct opening height for the specific flooring thickness before ordering.
- Keep individual lengths in their plastic wrap until installation to protect the finish.
- Order sufficient length allowing for cuts at doorways and transitions.
