Description
Loba Fugenkittlosung Solvent Based Binder – 5 Litres
Loba Fugenkittlosung is a solvent-based sawdust binder. This classic joint putty
solution has proven to be absolutely ideal in the renovation industry. Thanks to
the highly volatile solvents, the danger of reactions with residues of old
coatings in the wood is less than with Water-based systems. After drying the
woodfiller shows excellent filling and adhesion features.
Product Advantages
- Rapid drying
- Excellent sanding properties
- Exceptional color fidelity even with exotic wood species
- Prevents finish shrinkage
Range of Uses
- For closing joints and small areas of damage to bonded parquet
and hardwood floors. - Old flooring with outsized and dirty joints, as well as wooden
constructions involving nailed or screwed hardwood floors, are not generally
treated with putty, as the dried putty will break out at least in some parts
Application
- The surface must be professionally sanded.
- The floor must be dry and free of any old coatings,
oil, grease, wax, silicone, sanding dust and other impurities. - The optimal processing conditions are room temperature +15°C
to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% to 75%,
material temperature +18°C to + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms. - In order to prevent parquet damage, the room temperature
should be set to the annual average expected for the use of theproduct. - Shake the contents well.
- Observe general and, if necessary, product-specific occupational
health and safety regulations. Further information can be
found in the GISCODE-related operating instructions which are
available under www.wingis-online.de.
THINNER / MIXING
- The product is ready for use and must not be reduced!
APPLICATION TOOL / APPLICATION RATE
- LOBA trowel / approx. 100 ml/m2 (10 m²/l). Consumption may
vary depending on the joint width.
DRYING TIME
- For fine joints, sand after no less than 30 minutes.
- Rework with the recommended surface treatment systems after
no less than 2 hours.
SYSTEMS SUITABLE FOR SURFACE TREATMENT:
- All LOBA finish and oil systems.
APPLICATION:
- After the medium sand (e.g. 60 grain) and before the fine
sand (e.g. 100 grain) - Mix the product with the finest wooden sanding dust as
possible for the type of wood in question to form a paste-like,
silky putty. - The finer the sawdust used, the easier the putty will be to apply
and therefore the better its adhesion to the joint. - The entire floor is scraped off before the fine sanding stage.
- For larger joints or damage, repeat the process after drying.
- Carefully remove the remainder from the surface.
- Completely sand away (fine sanding) any putty remaining on
the surface after drying. - Tip: A perfect color result is achieved at a mixing ratio of 1:10 by
weight (sanding dust content to binder).
