Description
Max Bond Max Prime Porous Primer
– 15 Litre Flask
MJS Max Prime is a water based acrylic primer designed to prime absorbent substrates prior to the application of water-based adhesives.
Used For:
- Most highly absorbent substrates such as concrete, timber, solid plaster, plasterboard, cement sheet and cementitious screeds.
Applicable Standard:
- Australian/NZ Standard 2455.1.1995 – “Textile Floor Coverings Installation Practice”.
Surface Preparation:
- All surfaces to be primed should be dry, smooth, and free of any contaminates that may affect final bond.
- It is highly recommended that all absorbent sub-floors be primed with MAX PRIME prior to the application of adhesive.
- The minimum sub floor temperature prior to commencing preparation or primer application is 10ºC.
Method of Application:
- Max Prime should be applied evenly over the entire sub-floor by Soft Broom or Brush.
- Highly absorbent sub floors may require a second coat of Max Prime.
- Allow first coat to dry prior to applying further coats
Clean Up:
- Clean tools immediately after use with warm soapy water.
Shelf Life:
- Up to 12 months in sealed container at 20ºC.
Properties:
- Appearance: White Liquid
Safety and Handling:
- Refer to Safety Data Sheet
Note: Always carry out your own test to confirm suitability of this product
with your application. Additional information on physical properties, health
hazards, storage, handling and transport is available in the Material Safety Data
Sheet (MSDS), available on MJS website.
