Environex Clearseal Sealer

Description

Environex Clearseal Sealer
– 1, 5 and 15 Litres

 

Environex Clearseal Sealer is a water-based siliconate sealer designed for use as a water repeller on masonry surfaces.
Environex Clearseal Sealer will assist in the prevention of moss and mould build-up.
It can also be used as a pre-seal or pre-grout treatment for very porous surfaces such as terracotta or sandstone. This will greatly assist in the cleanup of excess grout. It is particularly well suited for use around swimming pools where water marks can be a problem. For single leaf masonry brick walls spray application will reduce or prevent migration of water to inside of the wall.

 

DIRECTIONS FOR USE

Environex Clearseal Sealer should be applied when the surface is clean and dry.
Grease, oil or dirt will interfere with the effectiveness of the sealing or pre-sealing process.
A lambswool applicator or garden sprayer will give best results
THIS PRODUCT IS A ONE COAT ONLY APPLICATION.
APPLYING TOO MUCH PRODUCT WILL RESULT IN A WHITE RESIDUE THAT IS DIFFICULT TO REMOVE.
Apply enough product to soak into the surface.
Excess product in the form of pools should be removed immediately.
Allow 6 hours curing time – overnight if being used as a pre seal.
KEEP WELL AWAY FROM ALUMINIUM, STEEL AND TIMBER SURFACES.
Coverage is typically 12 m2/litre, but may vary from 8 m2/litre for very porous surfaces or tiles to 16 m2/litre for very dense surfaces or tiles.

 

CLEANUP

Cleanup is in water.

 

MAINTENANCE

Block walls sealed with Environex Clearseal Sealer should be cleaned using Environex REFRESH or MAESTRO if there is a moss or mould problem.
RECOATING should be done every 2 years or when water repellency has ceased.

 

DIRECTIONS WITH CLEARSEAL FOR MANUFACTURED, BLOCK OR WET CAST PAVERS

To reduce Efflorescence and introduce a pre-sealed block or paver from the factory process.
The use is 600ml of S M S per ton of cement to the mixture.
Firstly mix required water into the dry mix minus the 600ml and add after mixture has been combined.
(Do not add prior to water and mixing process)
If the mix is normally 44 litres (add 43.4 litres and 0.6 Litres of Sodium Methyl Siliconate)

 

DIRECTIONS WITH CLEARSEAL FOR MANUFACTURED OPTION/DRY WALL FILL

Follow the directions as above.
The only difference would be the amount water and CLEARSEAL to be added.
If the mix is normally 44 litres (add 36 litres and 8 litres of Clearseal) Per ton.
If the mix is normally 22 litres (add 18 litres and 4 litres of Clearseal). Per half ton. If the mix is normally 11 litres (add 9 litres and 2 litres of Clearseal). Per quarter ton.

 

SAFETY

STONGLY ALKALINE.
R35 Causes severe burns.
Avoid contact with skin and eyes.
S37/39 Wear suitable gloves and eye/face protections.

 

PACKAGING

1 Litre, 5 Litre, 15 Litre & 200 Litre containers

 

IMPORTANT NOTICE TO CUSTOMER

Since the use of this product is beyond the control of either seller or manufacturer, their only obligation shall be to replace any quantity of product which is proven defective. They cannot assume any risk or liability in excess of the purchase price of the product itself, which does not include labour or any consequential damages resulting from the use of this product. Determining the suitability of this product for any intended use shall be solely the responsibility of the user. ALWAYS TEST FIRST.