Dy-Mark Spray and Mark Water Based – 350g

General

Dy-Mark Spray and Mark Water based is a low toxicity marking paint that features an advanced UV resistant formula and a 360°C valve for any angle application. Dy-Mark Spray and Mark Water Based is a workplace friendly paint ideal for; construction, landscaping and civil works applications. Dy-Mark Spray and Mark Water Based is suitable for use with the Long Arm Handle and 2-Wheel Spot Marking Handle, also available from Dy-Mark.

Directions For Use

Suitable Surfaces:

• Concrete, bitumen, steel, timber and grass.

Ideal Application Temperature:

• Between 5ºC and 40ºC.
• Avoid use in windy conditions.

Before Spraying:

• Shake can for at least 45 seconds AFTER the mixing ball begins to rattle.
• Shake can occasionally during use.

Application:

• Hold can UPRIGHT or in the INVERTED position (upside down), and spray with the nozzle approximately 10-15cm from the surface. Adjust the spray width by moving closer or further away from the surface to be sprayed.

Coverage:

• Will produce 200+ ‘X’ marks, 80 to 100 lineal metres in a 50mm wide continuous line, or will cover 4 – 6m2 (depending on the surface and colour used).

Drying Time:

• Touch dry in 5 minutes (@25ºC)
• Drying time will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.

After Spraying:

• Prevent blocking by holding the can upright and spraying until only clear gas escapes. Also wipe spray tip of the nozzle clean of paint. Clean up wetpaint with Dy-Mark Acetone or General Purpose Thinner.

Caution:

• Painted surfaces may become slippery when wet. Refer to disclaimer in the TDS page 3.

Technical Data

• Size: 350ml Aerosol
• Colour: Blue, Yellow, White, Fluoro Green, Fluoro Pink and Fluoro Orange
• Finish: Matt
• Consistency: Liquid
• Propellant:
  1.     Dimethyl Ether

Storage

• Store locked up.
• Protect from sunlight.
• Do not expose to temperatures exceeding 50ºC/12ºC.
• Store in a well-ventilated place.

Disposal

Pressurised container:

• Do not pierce or burn, even after use.
• Aerosol should be completely emptied prior to disposal.
• Dispose of contents/container according to regional regulations.

First Aid/Safety Information

Please refer to the Safety Data Sheet (SDS) before use. 
To view the correct SDS, please refer the back of the can under the section “CONTAINS” to confirm which formulation is used and to match up the details with Section 3 of the SDS which contains the formulation.
Safety data sheets are also available from the dymark website at www.dymark.com.au