Dy-Mark Professional Line Marking Paint – 500g

General

Dy-Mark Professional Line Marking paint is a fast drying, epoxy based paint specially formulated to provide high coverage, excellent adhesion and high wear resistance for long lasting professional quality lines. It is also resistant to most general chemicals like detergents, petrol and oil. With added UV stabiliser it has high UV resistance for long lasting lines in the harsh Australian climate. Dy-Mark Professional Line Marking paint is ideal for marking lines on high wear surfaces.

Advantages

• lasts 3X longer than acrylic based line marking paints
• Epoxy Based Formula
• High Wear Resistance
• Crisp Sharp Lines
• Added UV Stabiliser
• Excellent Adhesion
• Fast Drying

Directions For Use

Suitable Surfaces:

• Concrete, bitumen, grass and timber.

Ideal Application Temperature:

• Between 5ºC and 40ºC.
• Avoid use in windy conditions.

Preparation

• Surface should be clean, dry and free from contaminants such as grease, dirt and salt.

Before Spraying:

• Shake can for at least 45 seconds AFTER the mixing ball begins to rattle.
• Shake can occasionally during use.

Application:

• For INVERTED USE only. Insert can into the Dy-Mark Line Master machine’s spot marking handle. Ensure the nozzle is correctly seated.
  To achieve the narrowest line width, the spot marking handle must be inserted into the lowest position. Line width can be increased by raising the handle in the slot. Line width can be adjusted approximately 60-100mm. Test line width on cardboard sheet until desired width is achieved. Masking wheels are designed to sharpen the lines by catching any overspray at the edges only. When marking grass/turf consider using Dy-Mark Turf Master paint as it will minimise damage to the grass.

Drying Time:

• Touch dry in 15-20 minutes (@25ºC)
• Recoat within approx. 1 hour
• Hard dry in 4 hours
• Vehicular traffic within 16-24 hours
• Drying time will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.

After Spraying:

• Prevent blocking by holding the can upright and spraying until only clear gas escapes. Also wipe spray tip of the nozzle clean of paint. Clean up wet paint with Mineral Turpentine or Dy-Mark Xylene or General Purpose Thinner

Caution:

• Painted surfaces may become slippery when wet. Refer to disclaimer in the TDS page 3.

Technical Data

• Size: 500g Aerosol
• Colours: Yellow, White, Disabled Blue (B23) and Golden Yellow (Y14)
• Finish: Matt
• Consistency: Liquid
• Coverage: Will produce 80-100m in a 50mmm wide continuous line, or 4-6m2 coverage

Storage

• Store locked up.
• Protect from sunlight.
• Do not expose to temperatures exceeding 50ºC
• Do not store in vehicles under hot conditions
• Store in a well-ventilated place.

Disposal

Pressurised container:

• Do not pierce or burn, even after use.
• Aerosol should be completely emptied prior to disposal.
• Dispose of contents/container according to regional regulations.

First Aid/Safety Information

Please refer to the Safety Data Sheet (SDS) before use. 
Safety data sheets are also available from the dymark website at www.dymark.com.au
call a POISON CENTRE:Australia 13 11 26, New Zealand 0800 764 766 or doctor/physician if you feel unwell. Intentional misuse by deliberately inhaling contents can be harmful or fatal. KEEP OUT OF REACH OF CHILDREN